Vivitek D7 Series User Manual

D7 SeriesUser Manualϡ͗͘Ί⫼᠋᠟ݠManual del usuarioManuel de l'utilisateurBenutzerhandbuch㇠㟝㣄 ㉘⮹㉐ɊɭɤɨɜɨɞɫɬɜɨɩɨɥɶɡɨɜɚɬɟɥɹGebruikershandleiding,QVWUXN

DLP Projector – User’s Manual Views of Projector Parts Front-right View 123456 ITEM LABEL DESCRIPTION SEE PAGE: 1. Lamp cover Removes cover to

DLP Projector – User’s Manual Rear view 123456789121110 ITEM LABEL DESCRIPTION SEE PAGE: Connect the RGB CABLE to a display (Loop Thru only for

DLP Projector – User’s Manual Bottom view 70.00110.00126.00228.0020.0056.00146.00236.00100.0 240.0123332 ITEM LABEL DESCRIPTION SEE PAGE: 431. S

DLP Projector – User’s Manual Remote Control Parts Important: 1. Avoid using the projector with bright fluorescent lighting turned on. Certain hig

DLP Projector – User’s Manual – 6 – ITEM LABEL DESCRIPTION SEE PAGE: 1. IR transmitter Transmits signals to projector 2. Status LED Lights w

DLP Projector – User’s Manual – 7 – Remote Control Operating Range The remote control uses infrared transmission to control the projector. It is not

DLP Projector – User’s Manual SETUP AND OPERATION Inserting the Remote Control Batteries – 8 – 1. Remove the battery compartment cover by sliding

DLP Projector – User’s Manual Connecting Input Devices A PC or notebook computer and video devices can be connected to the projector at the same tim

DLP Projector – User’s Manual Starting and Shutting down the Projector 1. Connect the power cord to the projector. Connect the other end to a wall

DLP Projector – User’s Manual 5. When the “Power Off? /Press Power again” message appears, press the POWER button. The projector turns off. Cautio

Copyright This publication, including all photographs, illustrations and software, is protected under international copy-right laws, with all rights

DLP Projector – User’s Manual Setting an Access Password (Security Lock) You can use the four (arrow) buttons to set a password and prevent unauthor

DLP Projector – User’s Manual 5. You can use the cursor buttons ▲▼◄► either on keypad or IR remote control for password entry. You can use any comb

DLP Projector – User’s Manual Adjusting the Projector Level Take note of the following when setting up the projector: • The projector table or stan

DLP Projector – User’s Manual Adjusting the Keystone 1. Volume+-Use the KEYSTONE buttons the remote control to correct image-trapezoid (wider top o

DLP Projector – User’s Manual Adjusting the Volume 1. Volume+-Press the Volume +/- buttons on the remote control. The volume control appears on

DLP Projector – User’s Manual ON-SCREEN DISPLAY (OSD) MENU SETTINGS OSD Menu Controls The projector has an OSD that lets you make image adjustments

DLP Projector – User’s Manual Setting the OSD Language Set the OSD language to your preference before continuing. 1. Press the MENU button. Press t

DLP Projector – User’s Manual – 19 – OSD Menu Overview Use the following illustration to quickly find a setting or determine the range for a setting

DLP Projector – User’s Manual OSD Sub-Menu Overview – 20 –

DLP Projector – User’s Manual Image Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the Image Menu. Press th

DLP Projector – User’s Manual — ii — Important Safety Information Important: It is strongly recommended that you read this section carefully before

DLP Projector – User’s Manual Advanced Feature Press the Menu button to open the OSD menu. Press ◄► to move to the Image menu. Press ▼▲ to move to t

DLP Projector – User’s Manual Color Manager (Enter) / ► to enter the Color Manager sub menu. Press ITEM DESCRIPTION Select to enter the Red Colo

DLP Projector – User’s Manual Computer Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the Com-puter menu. P

DLP Projector – User’s Manual Video/Audio Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the Video/Audio me

DLP Projector – User’s Manual Audio (Enter) / ► to enter the Audio sub menu. Press ITEM DESCRIPTION Volume Press the ◄► buttons to adjust the aud

DLP Projector – User’s Manual Installation I Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the Installa-ti

DLP Projector – User’s Manual Advanced Feature Press the Menu button to open the OSD menu. Press ◄► to move to the Installation I menu. Press ▲▼ to

DLP Projector – User’s Manual Installation II Menu Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the Installa-t

DLP Projector – User’s Manual Advanced Feature Press the Menu button to open the OSD menu. Press ◄► to move to the Installation II menu. Press ▲▼ to

DLP Projector – User’s Manual OSD Menu Setting ITEM DESCRIPTION Menu Position Press ◄► button to select different OSD location. Translucent Menu

Preface Projector Installation Notice ¾ Place the projector in a horizontal position The tilt angle of the projector should not exceed 15 degrees,

DLP Projector – User’s Manual Lamp Hour Reset Please refer to on page 41 to reset the lamp hour counter. Lamp Hour Reset 3D ITEM DESCRIPTION 3D

DLP Projector – User’s Manual Network ITEM DESCRIPTION Network State Displays the network connection status. Press ◄► to turn DHCP On or Off. DH

DLP Projector – User’s Manual For simplicity and ease of operation, the projector provides diverse networking and remote management features. The LA

DLP Projector – User’s Manual 3. Right-click on Local Area Connection, and select Properties. 4. In the Properties window, select the General tab,

DLP Projector – User’s Manual 7. Press the Menu button on the projector. 8. Select Installation II → Advanced→ Network. 9. After getting into Netwo

DLP Projector – User’s Manual CATEGORY ITEM INPUT-LENGTH IP Address 14 – 37 – IP ID 2 Crestron Control Port 5 Projector Name 10 Location 9 Pr

DLP Projector – User’s Manual Factory Reset Press the cursor ▲▼ button to move up and down in the Installation II menu. Select the Factory Reset sub

DLP Projector – User’s Manual – 39 – MAINTENANCE AND SECURITY Replacing the Projection Lamp The projection lamp should be replaced when it burns out

DLP Projector – User’s Manual – 40 – 2. Remove the lamp compart-ment cover. 3. Remove the two screws from the lamp module. 4. Lift the module hand

DLP Projector – User’s Manual Resetting the Lamp After replacing the lamp, you should reset the lamp hour counter to zero. Refer to the following: 1

DLP Projector – User’s Manual — iv — Power Safety ¾ Only use the supplied power cord. ¾ Do not place anything on the power cord. Place the power c

DLP Projector – User’s Manual – 42 – Cleaning the Projector Cleaning the projector to remove dust and grime will help ensure trouble-free operation.

DLP Projector – User’s Manual Using the Physical Lock ®Using the Kensington– 43 – Lock If you are concerned about security, attach the projector to

DLP Projector – User’s Manual – 44 – TROUBLESHOOTING Common problems and solutions These guidelines provide tips to deal with problems you may enco

DLP Projector – User’s Manual – 45 – LED Error Messages ERROR CODE MESSAGES WARNING LED LAMP LED BLINK POWER LED BLINK Power On 0 0 Blue Power O

DLP Projector – User’s Manual – 46 – Lamp Problems Problem: There is no light from the projector 1. Check that the power cable is securely connect

DLP Projector – User’s Manual – 47 – HDMITM Q & A Q. What is the difference between a “Standard” HDMITM cable and a “High-Speed” HDMITM cable? R

DLP Projector – User’s Manual – 48 – SPECIFICATIONS Specifications Note: For questions regarding product specifications, please contact your local

DLP Projector – User’s Manual Projection Distance vs. Projection Size DLHImage HeightWImage Width Projection Distance and Size TableD795WT D791ST –

DLP Projector – User’s Manual – 50 – Timing Mode Table The projector can display several resolutions. The following table outlines the resolutions t

DLP Projector – User’s Manual – 51 – SIGNAL RESOLUTION H-SYNC (KHZ) V-SYNC(HZ) COMPOSITE / S-VIDEOCOMPONENT RGB (ANALOG) DVI/ HDMITM (DIGITAL)720

Preface – v – Main Features • Lightweight unit, easy to pack away and transport. • Compatible with all major video standards including NTSC, PAL,

DLP Projector – User’s Manual Projector Dimensions (mm) 319.00354.00411.00219.00157.00 – 52 –

DLP Projector – User’s Manual – 53 – REGULATORY COMPLIANCE FCC Warning This equipment has been tested and found to comply with the limits for a Clas

DLP Projector – User’s Manual – 54 – APPENDIX I RS-232C Protocol Note: Not all functions are available for all models due to different series. RS232

DLP Projector – User’s Manual – 55 – Remote Command The remote commands simulate the code send from IR remote handset. Button’s name ASCII HEX UP

DLP Projector – User’s Manual – 56 – Query Command ITEM ASCII HEX Software Version ~ q V CR 7Eh 71h 56h 0Dh Power State ~ q P CR 7Eh 71h 50h 0

2010092010 Vivitek Corporation. All rights reserved. All trademarks are the property oftheir respective owners. All specifications are subject to chan

DLP Projector – User’s Manual — vi — Table of Contents GETTING STARTED...

Preface – vii – SPECIFICATIONS.........

DLP Projector – User’s Manual – 1 – GETTING STARTED Packing Checklist Carefully unpack the projector and check that the following items are included