Vivitek D536-3D Specifications download pdf (Page 4)

—

’

Power Safety

¾ Only use the supplied power cord.

¾ Do not place anything on the power cord. Place the power cord where it will not be in the way of

foot traffic.

¾ Remove the batteries from the remote control when storing or not in use for a prolonged period.

Replacing the Lamp

Replacing the lamp can be hazardous if done incorrectly. See Replacing the Projection Lamp on page 36

for clear and safe instructions for this procedure. Before replacing the lamp:

¾ Unplug the power cord.

¾ Allow the lamp to cool for about one hour.

Cleaning the Projector

¾ Unplug the power cord before cleaning. See Cleaning the Projector page 39.

¾ Allow the lamp to cool for about one hour.

Caution:

In rare cases the lamp bulb may burn out during normal operation and cause glass dust or shards

to be discharged outward from the rear exhaust vent.

Do not inhale or do not touch glass dust or shards. Doing so could result in injury.

Always keep your face away from the exhaust vent so that you do not suffer from the gas and bro-

ken shards of the lamp.

Regulatory Warnings

Before installing and using the projector, read the regulatory notices in the Regulatory Compliance on

page

51.

Important Recycle Instructions:

Lamp(s) inside this product contain mercury. This product may contain other electronic waste that

can be hazardous if not disposed of properly. Recycle or dispose in accordance with local, state, or federal

Laws. For more information, contact the Electronic Industries Alliance at

WWW.EIAE.ORG. For lamp

specific disposal information check WWW.LAMPRECYCLE.ORG.

Symbol Explanations

DISPOSAL: Do not use household or municipal waste collection services for

disposal of electrical and electronic equipment. EU countries require the use

of separate recycling collection services.

— iv —

1 2 3 4 5 6 7 8 9 ... 60 61

No comments

Vivitek D536-3D Specifications Page 4