T470 User’s manual V027B, © JED Microprocessors Pty Ltd 2015 Page 3
RS232 connections to BenQ projectors with D9, female on projector
These all use a D-sub 9-pin connector, female on projector, male on cable. Communications runs at 19200 8N1.
Connection
(Male on cable)
Reply data from projector to T470
After installation wiring of any projector to a T470, use a multimeter to check voltages of –9 on BOTH TX
and RX pins in any installation, as described in the troubleshooting part of this manual. A useful check that
you have actually connected to a valid RS232 input on the projector is to unplug the cable from the
controller and measure resistance down the cable to ground using a multimeter on the “K-Ohms” setting.
This should be 4k to 8 K-Ohms.
BenQ No CR: Code 1200h
BenQ SH960 (These differ from usual BenQ codes, in that there is no <CR> either side of command string.)
• BlankOn/BlankOff, SoundMuteOn/SoundMuteOff and Freeze/Unfreeze are all supported if appropriate
buttons are allocated. Combined Blank/SoundMute is also supported with a keyboard option. These are
absolute functions and a LED indicates the current state;
• AspectRatio4:3 and AspectRatio16:9 are supported if an AspectRatio key is allocated. This is a rolling function
with no LED indication of state;
• Audio Volume range is limited and incremental. Some BenQ projectors do not have audio out, and audio
inputs are often limited;
• Off LED Comms-OK (one blink) and NoComms (three blinks) is supported;
3
D-sub 9 male
solder side
4 25 1
9 8 7 6
Comments to this Manuals